Cisco ios xe command to copy ftp to flash

You can use a USB extension cable however USB hubs are not supported.Devices that have 2 USB ports, can use both USB memory sticks simultaneously.All ISR and ISR G2 routers support USB flash drives.USB interfaces are supported from IOS release 12.3 (14) T IP Base and later.Related to the information above let me add some more information about how USB Drives can be managed and used in Cisco IOS routers: Some Considerations about USB on Cisco IOS Routers Router # copy usbflash0: flash: ДЇrom now on, the router will be booting up from the internal flash memory. You can copy the image we have in our USB flash into the internal routerвЂ™s flash memory: Once the router has booted up, you can now work with the normal IOS command line interface. Program load complete, entry point: 0x8000f000, size: 0xe2eb30 Then run the command that orders the router to boot from the image stored on USB flash: Note: The command is dir usbflashx: where x assumes a value of 0 or 1 depending on which USB port of the router you are using. Then we can check our image stored on USB flash drive: In this mode we can see the list of available commands using the question mark or help command: If not, we can force entry into rommon mode by interrupting the boot sequence using вЂњ Ctrl + BreakвЂќ.ДЇrom this point, we can see the rommon mode prompt: If the device did not have a valid IOS image in the internal flash memory, it will go directly in that mode. Once we have this resource, we must enter into ROM Monitor mode (rommon). The obvious prerequisite of this procedure is to have a valid IOS image, which is suitable for the device you want to put into operation, stored on a USB flash drive. This mode gives a reduced set of commands that essentially allow the administrator to manually run the boot sequence.ДЇor such cases, and using commands in the ROMMON mode, the Cisco ISR routers have 1 or 2 USB ports that can be used to load the IOS image from a USB flash drive. In this case the device does not have a valid image to load and therefore the router boots into ROM monitor mode (rommon). However, it may happen that for various reasons the operating system image may not be available, maybe due to file corruption, flash memory corruption, accidental deletion, etc. The flash memory of Cisco routers is usually internal or can be a removable flash card on higher end routers. installerДЎ4 -rw- 205119800 16:32:14 +00:00 asr1000rp1-ipbasek9.02.04.02. routers typically store a copy of the deviceвЂ™s operating system (Cisco IOS) in their flash memory, and load this operating system image into RAM during the boot-up process. HOWEVER, after reboot, as shown below some directories are recreated. Router#delete /force /recursive tracelogs Router#delete /force /recursive tracelogs.923 Router#delete /force /recursive lost+found I actually deleted all directories and files under bootflash: by following commands. Here is the latest output by 'show file systems'. How to erase running-configuration in Cisco IOS-XE? I deleted startup and running config by following the instruction written here. Is there any special way to delete configuration on IOS-XE? To delete all configuration in regular IOS, I usually run 'write erase' and delete unnecessary file from 'flash' by 'delete flash:FILENAME' because I sometimes found backup configuration stored under flash. I would like to completely initialize the ASR1002 to securely pass the device to third party.

Cisco ios xe command to copy ftp to flash